Author Topic: Touch off stuff? Please explain.  (Read 156 times)

Beginner

  • Guest
Touch off stuff? Please explain.
« on: July 14, 2017, 10:57:20 AM »
My torch isn't doing an actual touch off. It floats above the plate and retracts to different heights, but my DRO for both the machine coordinates and the work coordinates are changing from where they were originally zeroed.  So with the touch off, is Mach automatically zeroing itself?

RandyRay

  • VERY Senior Engineer (i.e.old)
  • Administrator
  • Newbie
  • *****
  • Posts: 13
    • View Profile
    • Texas MicroCircuits
Re: Touch off stuff? Please explain.
« Reply #1 on: July 14, 2017, 10:57:50 AM »
When you do a touch off, you then zero your Z in work coordinates, and then retract a known distance. This helps a lot with the pierce, since a large sheet of metal can vary significantly in height due to:
* Warpage (typically in thinner metals)
* Inclines (Not laying flat across your bed
* Physical damage or splatter type debris on top of the sheet of metal.

If you were always working with thick steel plate (1/2" plus) you could probably get by without a touch off. If you are working with thinner stuff (i.e. doesn't lay flat every time all the time), I would really say that you should consider getting a touch off


Randy
Randy Ray
Owner/Architect
Fire-by-Wire/TMC3in1
Texas MicroCircuits