General Category > TMC3in1 FAQ

Torch pauses

(1/1)

Beginner:
After touching off and starting a pierce, the torch just sits there for a few seconds before it starts to move.  At the end of the cut the torch just sits there for a few seconds before it picks up to go to the next location.

RandyRay:
You most likely have delay times enabled in your spindle spin up and spin down settings.   Please go into Menu -> Config -> Ports and Pins -> Spindle Setup and make sure that for your General Parameters that all of the spindle delays are set to 0, since any other value will cause a delay.
Please refer to the Vol 4 FAQ and Troubleshooting Guide under Q5 for a photo of the settings in question.

Randy

Navigation

[0] Message Index

Go to full version