Author Topic: Allow THC control when not in THC mode on Mill Options tab?  (Read 122 times)

Beginner

  • Guest
Should I use the allow THC control even when not in THC mode on the mill options tab?


RandyRay

  • VERY Senior Engineer (i.e.old)
  • Administrator
  • Newbie
  • *****
  • Posts: 13
    • View Profile
    • Texas MicroCircuits
Re: Allow THC control when not in THC mode on Mill Options tab?
« Reply #1 on: July 14, 2017, 10:46:17 AM »
NO!  Don’t use it!  It takes away control from the THC On Off button on the main screen!  That option should ONLY be used for an Oxy-Acetylene setup where the operator will manually adjust Z height while cutting.

Please refer to the Vol 4 FAQ and Troubleshooting Guide under Q6 for a photo of the settings in question.

Randy
Randy Ray
Owner/Architect
Fire-by-Wire/TMC3in1
Texas MicroCircuits