General Category > TMC3in1 FAQ

Allow THC control when not in THC mode on Mill Options tab?

(1/1)

Beginner:
Should I use the allow THC control even when not in THC mode on the mill options tab?

RandyRay:
NO!  Don’t use it!  It takes away control from the THC On Off button on the main screen!  That option should ONLY be used for an Oxy-Acetylene setup where the operator will manually adjust Z height while cutting.

Please refer to the Vol 4 FAQ and Troubleshooting Guide under Q6 for a photo of the settings in question.

Randy

Navigation

[0] Message Index

Go to full version